Whole House Fluoride Filter 1 to 5 GPM

Whole House Fluoride Filter 1 to 5 GPM

Code: MS013500 List Price: $319.00 Your Price: Manufacturer: CWS Manufacturer#: MS013500
Not Yet Rated | Write the First Review
Download Filter Data Sheet

Questions? Get a Fast Answer to your water treatment problems, click here!

Whole House Fluoride Filter 4.5" x 10"

Benefits

  • Resintech Premium High Capacity SIR-900 Resin
    Extended surface area and pore distribution gives the media highest possible operating capacity and lowest leakage.
  • FDA Drinking Water Approved Construction Materials
    Sonic welded construction is a solvent free method to join and assemble plastic parts, producing the highest quality safest product
  • Oversized Cartridge for Maximum Media Fill
    AF Series cartridges have up to 50% higher capacity and extend cartridge life, due to the use of larger cartridges
  • Quality Produced and Made in the USA
    Cartridges are produced by Aries FilterWorks, a division of ResinTech. Strict quality control over all aspects of cartridge and media production allows complete traceability of every filter

Specifications

  • For 1 to 2 bathroom homes OR for Point of Use Applications at Kitchen Sink etc
  • Flow Rate Recommended - 1 to 5 gallons per minute
  • Capacity: Change every 1200 gallons for best results
  • Fluoride removal is achieved by utilizing the advanced media technology of ResinTech SIR-900 media.

Applications

Drinking Water

Consumers, who are concerned about fluoride in the municipal water supply for health reasons and require its removal, can benefit by the use of a fluoride removal cartridge at the Point of Use (POU).


Private Wells

Some areas of the country have high levels of naturally occurring fluoride. Wells Supply 15% of American populations with drinking water, and these wells are not subject to EPA regulations. These wells provide safe clean water, but occasionally can become contaminated, resulting in illness.


About Fluoride

Fluoride can occur in drinking water naturally as a result of the geological composition of soils and bedrock. Most water supplies contain some naturally occurring fluoride. Fluoride also enters drinking water in discharge from fertilizer or aluminum factories. The decision to fluoridate a water supply is made by the State or local municipality. EPA has set the level of protection for fluoride at 4.0 mg/L or 4.0 ppm, to prevent potential health risk.


Exposures to fluoride have increased since the early 1960s. At that time, drinking water and food and beverages prepared with fluoridated water accounted for nearly an individual’s entire fluoride intake. Today, exposure to fluoride comes from fluoridated dental products, as well as the voluntary addition of fluoride to drinking water.

  • Clean Water Systems & Stores, Inc., Water Treatment Equipment,Service & Supplies, Santa Cruz, CA