Nitrate Filter Includes:

• 3/4 inch or 1 inch pipe connectors and by-pass valve
• 2.0 cubic foot high capacity nitrate selective anion nitrate resin with 64000 grain capacity (removes approximately 32000 grains of nitrate as CaCO4)
• Fleck 7000 115v control valve

Specifications:

• All the filter media you need for the system is included.
• Nitrate levels in excess of 2 to 4 ppm are often a result of fertilizer run-off from agricultural operations or from leaking septic tank systems
• These automatic nitrate removal systems properly sized and maintained can reduce nitrate levels by 80%
• In place of toxic chemicals these systems regenerate with common water softening salt
• Sizing is important and a complete general mineral water analysis is recommended
• Sulfates affect performance and it is important to know the sulfate levels in addition to the nitrate levels
• Filter tank is NSF certified one piece seamless polyester construction for long life
• Max pressure recommended is 100 psi
• Maximum water temperature recommended 100F
• Advanced Fleck 7000-Meter on-demand electronic backwash control valve features fully adjustable backwash and rinse cycles and is loaded with features
• Precise electronic meter measure the amount of water used and regenerates the nitrate filter based on actual water usage saving salt and water.
• Reliable electronic control provides quick setup and easy programming.
• Quick-connect clips allow easy installation and maintenance.
• Non-corrosive high-tech material construction. High flow bypass valve included.
• Environmental cover (NEMA-3R rated) protects control from the weather can be installed inside or outside if protected from freezing.
• Best nitrate filtration occurs with maximum 5.0 gallons per minute flow rate although higher flow rates for brief periods are possible.

Dimensions:

• Filter tank diameter: 12 inches
• Height including control valve: 59 inches
• Brine tank: 18 x 33 inches