AP1 Air Pump – Specifications & Overview

The AP1 Air Pump is engineered in the USA and built for hassle-free performance in residential and light commercial well-water aeration systems. This compact yet heavy-duty compressor delivers oil-less, medically safe compressed air, enabling effective oxidation of iron, manganese, and hydrogen­sulfide gases. Its rugged aluminium body and stainless valves are designed for reliable operation over 20,000–25,000 operating hours, with minimal service requirements.  

Why Choose the AP1?

• Eliminates the need for complicated venturi injectors and sizing concerns.  
• Introduces air on the outlet side of the pressure tank — avoiding buildup of precipitated iron in the pump/pressure system.  
• Oil-less, contamination-free air for safe, long-term service.  
• No added back-pressure on your well pump — the AP1 uses induction motor technology and rock-piston compression.  
• Quiet and compact (~8 lbs, ~50 dB) — fits into equipment bays without excessive noise or size.  

Technical Specifications

• Flow capacity: Supports systems up to approximately 15 gallons per minute. (Install appropriate retention/vent tanks.)
• Air production (AP1 model): 0.38 CFM @ 0 PSI; 0.15 CFM @ 50 PSI. 
• Maximum pressure rating: up to 100 PSI (70 PSI recommended) for AP1. 
• Electrical (AP1 model): 115 V / 60 Hz / 241.5 W / approx. 2.44 Amps.
• Weight: ~8 lbs. Noise: approx. 50 dB. Temperature range: 40°F – 100°F (indoor only). 

Installation & Maintenance Highlights

• Mount vertically when possible, with outlet port facing down to reduce moisture and debris accumulation.
• The pump should be installed **above** the aeration/retention tank or injection point — this allows condensate to drain and avoids performance degradation. 
• Self-lubricating design — no oil required. Compression cup should be replaced approximately every 12,000 hours, with annual inspection recommended. 
• The AP1 is water-resistant, not waterproof. Protect from rain, direct water spray, or highly humid environments. Use an air dryer in humid locations. 

Made in the USA & Warranty

This air pump is designed and manufactured in the USA to ensure high-quality components and workmanship. A one-year unlimited manufacturer’s warranty covers defects in materials or workmanship for original purchaser.

Support & Accessories

Make sure to include the recommended installation accessories: 0-100 PSI pressure gauge, two ¼″ check valves, an air regulator valve (ARV), 3/8″ polyethylene tubing with appropriate connectors, and vibration mounts or mounting shelf. 

Quick Specification Summary

• Flow rate: Up to ~15 GPM
• Voltage: 115 V (AP1 model)
• Weight: ~8 lbs
• Max Pressure: 100 PSI (70 PSI recommended)
• Noise: Approx. 50 dB
• Mounting: Indoor, vertical preferred
• Made in the USA