Stainless Steel Flex Line Falcon 3/4" FIP x Push-to-Connect x 18"
Simply push on to any 3/4" copper, CPVC or PEX piping -- no tools required! Brought to you by a collaboration between Falcon Stainless and John Guest USA. Eliminates the need for expensive brass compression fittings or copper male adaptors. Only from Falcon Stainless.
Falcon Stainless, Inc. warrants its products against manufacturers defect for the Lifetime of the installation. Should a Falcon Stainless steel corrugated water connector be found to be defective, (limited to tube failure, pinhole, cracks, or bursting) it must be returned to Falcon Stainless, Inc., directly, and without delay; and it shall be replaced at no charge.
All Falcon Stainless corrugated water connectors are warranted to be manufactured in compliance with ASME, ANSI, UPC and IPC standards. Ultimate responsibility for code compliance rests entirely with purchaser and/or installer. Falcon Stainless, Inc. assumes no responsibility for failure due to improper installation. Falcon Stainless, Inc. assumes no responsibility for damages caused by errors in installation. Falcon Stainless, Inc. does not warranty the installation or the installer. Under no circumstances will Falcon Stainless, Inc. be liable for mold remediation, labor or consequential damages to property, real or personal resulting from improper use or installation.
Falcon Stainless, Inc. will not be responsible for damage to washers caused by sharp or irregular mating surfaces, i.e. copper adaptors, brass nipples, or galvanized nipples that may cut into and compromise the seal of the washer. It is the installers responsibility to ensure washer-mating surfaces are smooth and flat to prevent such damage and resultant leaks.
This Warranty covers use in exposed and readily accessible locations for potable water only, and does not cover direct chemical or solvent contact, misuse or abuse of product.
Manufacturer: Falcon Stainless
Manufacturer #: PTC34JG-18