Flow Control PVC 3.0 GPM 1" MPT

Description

Our flow controls provide an efficient way to ensure your backwash flow rates stay at the right level. 

These flow controls are designed for 20 to 120 psid before the flow control. Back pressure after the flow control will likely reduce the flow rate to a gpm below the design parameters of the flow control. Increasing the pipe and drain sizes after the flow control could eliminate potential backpressure.

These simple-to-install units are constructed of corrosion-free, machined PVC.

• Max. Operating Pressure: 150 psi
• Max. Operating Temperature: 140 ℉ (60 ℃ )
• Materials: PVC & Buna-N (Standard)

The PVC flow control bodies are machined and cleaned in the USA.       

Certifications:

These parts are machined from PVC bar that is NSF 61 certified and made in the USA.

Dole-type rubber flow components are 372 for Annex G of 61.