Flow Control PVC 15.0 GPM 1" MPT

Description

Our flow controls provide an efficient way to make sure your backwash flow rates are kept at the right flow. 

These flow controls are designed for 20 to 120 psid before the flow control. Back pressure after the flow control likely will reduce the flow rate to a gpm below the design parameters of the flow control. Increasing pipe size and drain size after the flow control could eliminate potential back pressure.

These simple to install units are constructed of corrosion-free machined PVC.

• Max. Operating Pressure: 150 psi
• Max. Operating Temperature: 140 ℉ (60 ℃ )
• Materials: PVC & Buna-N (Standard)

The PVC flow control bodies are machined and cleaned in the USA.       

Certifications:

—           These parts are machined from PVC bar that is 61 certified and made in the USA.

—           Dole-type rubber flow components are 372 for Annex G of 61.