- SPECIALS! SAVE BIG $$ On New and Refurbished Softeners & Filter Systems
- Diagrams & Schematics
- Gifts & Offers Page
- Popular Systems
- City Water Systems
- Well Water Systems
- Acid Neutralizer Filters
- Arsenic Filters
- Bacteria Disinfection
- Carbon Backwash Filters
- Carbon Whole House Cartridge Filters
- Well Water Chlorination Systems
- Filters & Strainers
- Hydrogen Peroxide Well Water Systems
- Irrigation Rust Prevention
- Iron & Manganese Filters
- Metering Pumps & Parts
- Nitrate Filters
- Odor Systems
- Ozone Systems
- Phosphate Crystal Feeders
- RO High Flow
- RO Under-Sink
- Sediment Backwash Filters
- Soda Ash Systems
- Soda Ash Standard
- Soda Ash Proportional
- Contact Tanks
- Salt-Free Softeners Scale Stoppers
- Tannin Filters
- Ultraviolet Sterilizers
- Ultra Filtration Systems
- Books On Well Water Treatment
- Drinking Water Systems
- Replacement Parts and Valves
- Filter Tanks & Housings
- Filter Cartridges
- Travel & Emergency Purifiers
- Water Testing
- Commercial Systems
- Water Quality Programs
- Water Treatment Systems
- Filter Media, Chemicals & Supplies
Soda Ash Proportional
|Very Low pH? Blue stains from acid water?
Are pinhole leaks threatening to destroy your house with expensive leaks?
Now you can eliminate corrosion of copper and galvanized pipes, fixtures & appliances without raising the hardness of water.
Stop pin hole leaks. Stop blue green stains on fixtures!
Works great for very low pH in the range of 4.5 to 6.0. Safely raises the pH to the 7.0 to 8.0 range. Soda ash (sodium carbonate) is a powder that is mixed with water and injected into the water pipe before the pressure tank to raise the pH of water. By dissolving 2 to 3 lbs of soda per gallon of water and injecting this solution at a rate of 100 ppm to 200 ppm, the pH will rise to the 7.0—8.0 range, assuming a typical well water flow rate of 5 to 30 gallons per minute.
Our standard soda ash pump is the Precision-24 which can pump 24 gallons of solution in 24 hours of the well pump running.
Examples of copper pipe from some of our customers who had very low pH (acidic) well water. You can see the green copper oxide inside the pipe. This indicates corrosion is occuring...
|Why its best to buy it from us: we offer you free expert help in selecting and setting up your soda ash system. The result is you save time and money and end up with a reliable, easy-to-use system.|
3 methods to install a soda ash pump for a home well system:
|1. Wire it so the soda ash pump turns on when the well pump turns on. This is the lowest cost and most common method of installing a soda ash feeder.
|2. Use a proportional water meter that allows the soda ash pump to pump more or less soda ash solution based on the flow rate or speed of the water.
|3. Use a flow switch, so that when there is flow, the metering pump turns on.
Please contact us for design help in selecting the best system for your needs or if you have any questions. Call us toll-free at 1-888-600-5426